Twiflex MR Brake Calipers and Thrusters
The Twiflex MR series of disc brake calipers is suitable for use with discs of 12.7mm or 25.4mm thick. Minimum disc diameter is 250mm. Minimum disc diameter for the MR2 is 460mm.
Normally one or two calipers are used per disc, but the number may be increased depending on disc size. The brakes may be positioned at any angle around the periphery of the disc, but should ideally be mounted horizontally (i.e. at the 3 o’clock or 9 o’clock position). If the caliper mounting angle is greater than 10° from the horizontal, or on vertical shaft applications, it should be fitted with an equalising link. A range of brake discs is available from Howdon (see Disc and Hub Assemblies).
For pneumatic operation use dry, filtered and non-lubricated compressed air. Pneumatic brakes require a control valve, operated either manually or by pneumatic or electrical signal.
The ratings shown on the graphs are based on fully bedded in and conditioned brake pads with a nominal friction coefficient μ = 0.4. Howdon disc brakes must be used with Twiflex asbestos free brake pads.
Effective disc radius = actual radius (m) – 0.03m.
AVAILABLE SPARES
Brake Pads ( pack of 4 ) Part number 0780123- Z - SS4
Arm Assembly – Thruster Side. Part No. 6600112
Arm Assembly – Opposite Side Part No.6600113
Caliper Base Part No.8030010
Pad Spring Part No.7900024
Spring Kit (items 5 and 6) Part No.7902811
MR Spring Kit Part No. 7902811
Please refer to data sheets for more information.