+44 (0)1453 750814 

Twiflex MX Brake Calipers and Thrusters 

The Twiflex MX13, MX25, MX30 and MX40 series of disc brake calipers is suitable for use with discs of 12.7mm, 25.4mm, 30mm and 40mm thick respectively. The SMX caliper is only suitable for use with discs 12.7mm thick. Minimum disc diameter is 300mm. 
The MX/SMX calipers may be used with any of the Twiflex series of thrusters and feature a patented link mechanism to ensure uniform pad wear. 
Normally one or two calipers are used per disc, but the number may be increased depending on disc size. The brakes may be positioned at any angle around the periphery of the disc, but should ideally be mounted horizontally (i.e. at the 3 o’clock or 9 o’clock position). If the caliper mounting angle is greater than 10° from the horizontal, or on vertical shaft applications, it should be fitted with an inclined mounting kit or equalizing link. A range of brake discs is available from Howdon (see Disc and Hub Assemblies). 
For pneumatic operation use dry, filtered and non-lubricated compressed air. Pneumatic brakes require a control valve, operated either manually or by pneumatic or electrical signal. 
The ratings shown on the graphs are based on fully bedded in and conditioned brake pads with a nominal friction coefficient μ = 0.4. Howdon disc brakes must be used with Twiflex asbestos free brake pads. 
Effective disc radius = actual radius (m) – 0.033m. 
Brake pads ( Pack of 2 ). Part number 7080118 -Z -SS2 
Arm Assembly -Thruster Part No. MX13-6630145 
Arm Assembly -Slotted Part No. MX13-6630146 
Caliper Base Part No. MX13-8030025 
Pivot Pin Part No. MX13-7952383 
Retaining Plate Part No. MX13-7951480 
Spring Anchor Plate Part No. MX13-7951501 
Spring Kit Part No. MX13-7902813 
Please refer to data sheets for more information. 
Data Sheets - Direct Acting 
Data Sheets - Spring Applied 
Our site uses cookies. For more information, see our cookie policy. Accept cookies and close
Reject cookies Manage settings